Filter
Top Products
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
318-865-1711 FAX 318-862-2394
Printed in the United States Service Hotline
Page
13
1-800-24-FRYER
9.8 Replacing Hi-limit
a. Follow steps in Accessing plate and air
heaters, 9.7.
b. Remove the shield over the air heater
c. Remove the brace on the left side of the
base assembly, exposing the wire
raceway.
d. Remove the grommets the hi-limit
wiring passes through.
e. Remove the existing hi-limit and pull
wiring through cabinet.
f. Mount the hi-limit on the the spacers,
providing a stand-off from the panel..
g. Push the wires through the raceway
toward the transformer on the controller
side of the HLZ.
h. Slip the wires from the hi-limit into the
area occupied by the transformer.
i. Slip the hi-limit wires into the removed
grommets and snap back into place.
j. Plug the black wire leading from pin 1 in
the computer plug into the terminal of
the hi-limit.
k. Plug the other hi-limit terminal onto the
transformer.
l. Ensure all connections are tight.
m. Retie the wiring assembly
n. Replace the brace, which forms the wire
raceway.
o. Replace the metal shield over the air
heater.
p. Clear away the old adhesive holding the heater plate in place.
q. Put the single-back adhesive in place adhesive-side down and position the heater plate.
r. Ensure the heater plate’s ground wire is reconnected.
s. Plug the 15-pin connector into the computer and replace the controller housing.
t. Reassemble unit as described in step 9.9 below.
The wires for the hi-limit are routed through the hole
used by the RTD wiring. Slip the wires into slot
(shown above) and into the hole.
The wire is routed
from the air
cowling, through
the raceway,
emerging at the
transformer.