Filter
Top Products
Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
318-865-1711 FAX 318-862-2394
Printed in the United States Service Hotline
Page
14
1-800-24-FRYER
9.9 Reinstalling the Cowl Assembly and Air Delivery Assembly/Gasket Installation
a. Cowl Assembly:
1. Clean surface area thoroughly.
2. Remove any old adhesive.
3. Apply a new gasket to bottom edge of
the cowl assembly.
4. Test fit the cowl assembly to see if a
gap is visible once the cowl
assembly is properly seated. If a
gap remains, apply a second gasket
to create a better seal.
5. Plug in the computer harness and
reinstall the cowl assembly .
b. Air Delivery Tower Assembly:
1. Clean surface area thoroughly.
2. Remove any old adhesive.
3. Apply new gasket along bottom edge of the front air delivery panel.
4. Test fit the air delivery assembly to see if a gap is visible once the assembly is
properly seated. If a gap remains, apply a second gasket to create a better
seal.
5. Make sure the brackets on the back-side of the front air delivery assembly
slide up and under the nuts on the back air delivery mounting screws (see
figure 9-8). Once the front air delivery tabs clear the heater plate and the front
air delivery is seated, tighten the mounting screws to pull the front air delivery
flush against the back air delivery assembly. An air seal is created between
the lower sections of the front air delivery and back air delivery assemblies.
This seal forces the heated air up the rear and then down the front-side of the
front air delivery assembly. After reinstalling the air delivery tower, reseal
around the heater plate with RTV #108 silicone rubber compound, PN 811-
0511.
Apply gasket or sealant along this edge
Apply gasket or sealant along this edge