Gaggenau AH 530-720 Ventilation Hood User Manual


 
10
Cleaning the grease filters
The grease filter saturation display F flashes after
an operating time of 30 hours to indicate that you
should clean the grease filter (see Fig. 3). The
grease filter can of course be cleaned at any time,
even if the grease filter saturation display should
not start to flash.
The stainless steel grease filters can be removed
easily for cleaning (see Fig. 13):
Grip the grease filter handle and push the slide
towards the rear. Then pull the grease filter
downwards out of the holder; repeat the operation
for the other grease filters.
You can clean the stainless steel grease filters in a
dishwasher at a maximum temperature of 150 °F/
65 °C, where it should be supported vertically
to
allow food or rinsing residues to drain off.
The inner parts of the housing should be wiped out
with hot rinsing water when replacing the filters.
Note:
When cleaning the inside of the housing avoid
protruding parts.
After having cleaned them, re-insert the grease
filters in the hood in reverse order.
Important:
The handles of the grease filters must be
visible after assembly.
Press the F key to set the elapsed hours counter to
zero. Flashing of the indicating lamp goes off.
4. Cleaning and care
Fig. 13
Fig. 14