GE 200D9366P020 Refrigerator User Manual


 
10
Consumer Support Troubleshooting Tips Operating Instructions Safety Instructions
Installation
Instructions
About the freezer.
Freezer Shelves and Baskets
A shelf above the ice storage bin
A half-width basket
A deep full-width basket with divider
Basket Removal
To remove the deep full-width basket:
Open the freezer drawer until it stops.
Lift the freezer caddy up.
Pull the divider forward until the rear
locating tabs are out of the slots. Turn the
divider slightly to the side to release the
front locating tabs and lift out.
The freezer basket rests on the metal slide
brackets and is held in place with swing
locks.
Turn the swing locks from verticall to
horizontal position.
Open the refrigerator doors.
Lift the basket up and rotate it toward you.
Slide out from the side of the drawer.
When replacing the deep full-width basket:
Tilt the basket toward you and lower it into
the drawer.
Place the basket onto the metal slide
brackets and over the swing locks.
Turn the swing locks from horizontal to
vertical position to lock the basket
in place.
Turn the divider slightly to one side so the
tabs on the front fit into the vent slots on
the basket. Position the divider so the back
locating tabs snap into place in the back
vent slots.
Lower the freezer caddy ensuring the hook
fits over the front edge of the bottom
freezer basket. Push down to secure.
To remove the half-width basket:
Pull the basket out to the stop location.
Lift the basket up at the front to release it
from the slides.
Lift the back up and out of the slide.
CAUTION:Always be sure to
fully close this basket.
When replacing the basket, make sure that
the wire tabs and wire hooks on the sides
of the basket go into the slots in the top
of the upper basket slides.
Not all features are on all models.
Appearance and features may vary
Appearance may vary
Tabs
Tabs