GE JBP27GR Range User Manual


 
After a Clean Cycle
After cleaning is complete, the door will stay locked
2. Turn OVEN SET knob to OFF. Turn OVEN TEMP
until the oven cools down. This takes about 30 minutes.
knob to OFF (on some models).
1. When oven has cooled,
slide the latch handle
to the left as far as it
will go and open the
mi,
NOTE: To start
and
stop cleaning
at
a
time later than
~hown
on clock, push in and turn DELAY START
dial to time you wish cleaning to start. Then set STOP
TIME dial for three hours later than the Start Time.
door. If the door will Oven will automatically turn on and off at the set times.
not open, move the latch handle back to the right,
wait an additional 15 minutes and then try again.
Do not force the latch handle.
Questions and Answers
Q. Why won’t my oven clean immediately even
though I set all the time and clean knobs correctly?
A. Check to be sure your DELAY START dial is set
to the same time as the range clock. Also check to
be sure latch handle
is
moved to the right.
Q. If my oven clock is not working, can I still
self-
clean my oven?
A. No. Your Automatic Oven Timer uses the range
clock to help start and stop the self-cleaning cycle.
Q. Can I use commercial oven cleaners on any part
of my self-cleaning oven?
A. No cleaners or coatings should be used around any
part of this oven. If you do use them and do not
wipe the oven absolutely clean afterward, the
residue can scar the oven surface and damage
metal parts the next time the oven is automatically
cleaned.
Q. Can I clean the Woven Gasket around the
oven door?
A. No, this gasket is essential for a good oven seal,
and care must be taken not to rub, damage or move
this gasket.
Q. After having just used the oven, I could not
move the latch handle. Why?
A. After several continuous high-temperature bakings
or broilings, the door cannot be latched. If this
happens, let the oven cool by opening the oven
door. After the oven has cooled, you will be able to
latch the oven door for self-cleaning.
Q. What should I do if excessive smoking occurs
during cleaning?
A. This is caused by excessive soil, and you should
switch the OVEN SET knob to OFF. Open
windows to rid room of smoke. Allow the oven to
cool for at least one hour before opening the door.
Wipe up the excess soil and reset the clean cycle.
Q.
A.
Q.
A.
Q.
A.
Q.
A.
Q.
A.
Q.
A.
Is the “crackling” sound I hear during
cleaning normal?
Yes. This
is
the metal heating and cooling during
both the cooking and cleaning functions.
Should there be any odor during the cleaning?
Yes. there may be a slight odor during the first few
cleanings. Failure to wipe out excessive soil might
also
cause
an odor when cleaning.
What causes the hair-like lines on the enameled
surface of
my
oven?
This is a normal condition resulting from heating
and cooling during cleaning. They do not affect
how your oven performs.
Why do
I
have ash left in my oven after cleaning?
Some
types
of
soil will leave a deposit which is
ash. It can be removed with a damp sponge or cloth.
My oven shelves do not slide easily. What is
the matter?
Afler many cleanings, oven shelves may become
so
clean they
do
not s] ide easily. To make shelves
slide more easily after each self-cleaning cycle,
dampen
fi~lgers
with a small amount of cooking oil
and rub 1
ightly
over sides
of
shelf where they
contact
~helf
supports.
My oven shelves have become gray after the
self-clean cycle. Is this normal?
Yes. After the self-clean cycle, the shelves
miiy
lose
some
luster and
chan~e
to a deep gray color.
Q. Can I cook food on the cooktop while the oven
is self-cleaning?
A. Yes. While the oven is self-cleaning, you can use
the cooktop just as you normally do.
21
——
—...