Filter
Top Products
40
Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with
instructions for installation in a variety of
locations. The instructions include all necessary
information to complete the installation. Read
the Safety Instructions and the instructions
that fit your situation before beginning
installation.
WARNING:
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
• See instructions to install (supplied with bracket).
• Unless properly installed, the range could be
tipped by stepping or sitting on the door. Injury
may result from spilled hot liquids or from the
range itself.
9
Typical installation of anti-tip bracket attachment to wall
Bracket
Screw must
enter wood
or metal
Wall plate
REPLACE THE WIRE COVER
Replace the wire cover on the range back by
sliding its right edge under the retaining tab and
replacing the two screws removed earlier. Make
sure that no wires are pinched between the cover
and the range back.
8
LEVEL THE RANGE
Install the oven shelves in the oven and position
the range where it will be installed.
Check for levelness by
placing a spirit level or a
cup, partially filled with
water, on one of the oven
shelves. If using a spirit
level, take two readings—
with the level placed
diagonally first in one direction and then the
other.
On all models except warming drawer
models, remove the storage drawer, broiler
drawer or kick panel. The front leveling legs can
be adjusted from the bottom and the rear legs
can be adjusted from the top. (For warming
drawer models, see Step D.)
C
B
A
10
Leg
leveler
Lower
range
Raise
range
Front leveling legs
(on some models)
Rear leveling legs
(on some models)
Lower
range
Raise
range
Spirit level
Wire
cover
2 screws to
replace wire
cover
Retaining
tab
Back of range
Adjust from the
top
Adjust from
the bottom
Front of range