Filter
Top Products
-~—
Questions?
~
Use This Problem Solver
~
~
PROBLEM
OVEN WILL
NOT WORK
OVEN LIGHT DOES
NOT WORK
OVEN DOES NOT
COOK PROPERLY
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT OPEN
OVEN NOT CLEAN
AFTER CLEAN CYCLE
“door” APPEARS
ON DISPLAY
“F-”
AND A
NUMBER FLASH
ON DISPLAY
“OFF” APPEARS
ON
DISPLAY
POSSIBLE CAUSE AND REMEDY
● The circuit breaker
in
your house has been tripped, or a fuse has been blown.
● Oven controls not properly set.
“
Light bulb is loose or defective. Tighten or replace.
● Control panel is broken. Call for service.
● Aluminum foil being used improperly in oven.
s
Oven vent blocked,
● Oven shelf not level.
● Incorrect cookware being used. Check the Baking Guide for cookware tips.
● Clock set incorrectly.
● Controls set incorrectly. Review each cooking section.
● Shelf position is incorrect. Check Baking, Roasting and Broiling Guides.
●
Oven
temperature is too high to set self-clean operation. Allow the oven to cool to
room temperature and reset the
co~trols.
Q
Probe is in
oven.
—
● Oven must cool below locking
tempe~ature
(approximately 30 minutes after the clean —
cycIe
is complete).
● Oven controls not set properly.
● Heavily soiled ovens require
3~z
- to 4-hour Clean Time.
*
Heavy
spillovers
should be cleaned up before starting clean cycle.
● Oven door not closed after self-clean cycle selected.
● If “F-” and a number flash on display and the control beeps, this indicates a function
error code, Press the
CLEAWOFF pad. Allow oven to cool for one hour. Put oven
back into operation. If function error code repeats, disconnect power to the oven.
Call for service.
● Oven is too hot for Self-Clean.
*
Bake or Broil attempted too soon after Self-Clean.
● Other oven is in Self-Clean.
*
Child
Lockout feature turned on.
If you need more help. ..call, toll free:
GE Answer
Center@
800.626.2000
consumer information service
22