Filter
Top Products
Operating the Self-Cleaning Oven
Set the Oven for Cleaning
If range is too hot and you start to
set a clean cycle, the word "OFF"
will appear in the display. Allow
additional time for cooling before
you try to set the cycle.
NOTE: Only one oven at a time
can be self-cleaned. "OFF" will
appear in the display if you try to
clean both ovens at the same time.
1. Close the oven door completely.
2. Touch the CLEAN pad.
3. Touch INCREASE or
DECREASE pad. "3:00,""HR"
and "TIME CLEAN" will appear
on display. Three hours is the
programmed clean time, but any
time between two and four hours
can be set.
The door latches automatically.
If the oven door is not closed, the
word "DOOR" is displayed, the
word "LOCK" will flash _J_dthe
oven will signal. Close the door.
The signal will stop and the cleau_
cycle will start when the door
can lock.
When a clean cycle is finished, the
word "CLEAN" will be off
in the display.
You wil! not be able to open the
door unless the oven temperature
is at a safe level, when "LOCK"
goes out on display. Wait until the
oven has cooled, below locking
temperature (about 20-30 minutes).
NOTE: You can find out when the
clean cycle wi!! be finished by
pusbiog the STOP T.!ME pad.
To Set a Delayed Start
1. Close the oven. door completely.
2. Touch the CLEAN pad.
3. Touch. INCREASE or
DECREASE pad to enter
Clean Time.
4. Touch STOP TIME pad. "SET
STOP TIME" and. the earliest stop
time you can set wil! appear on
di sp! aT.
The earliest stop time wi)) be the
clean time selected. ,plus the time of
day. For exam!?!e: if the clean time
is three hours and the time of day
is 6:00, the stop time tbat appears
on display will. be 9:00.
5. Toucb INCREASE pad. to
change tbe stop time to a. later time
of day if desired. For example: if
you set stop time at I t :00, ove_
wi!! start clean cycle a.t 8:00 and
end a.t 1.1.:00.
NOTE: During a. delayed self-
clean operation you. car_ find out
whe_ the oven is set to turn or_ by
pushing and. holding the CLEAN
pad for 3 seconds.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
After Self-Cleaning
You may notice some white ash
in the oven. Just wipe it up with.
a damp cloth after the oven cools.
If white spots remain, remove
them with a soap-filled steel wool
pad. Be sure to rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed
by the clean cycle.
If the oven is not clean after one
clean cycle, repeat the cycle.
NOTE: A Bake or Broil function
cannot be programmed before the
door automatically unlocks.
If "F-" and a number flash
on display and the control
beeps, this indicates function
error code. Press CLEAR/OFF
pad. Allow oven to cool for one
hour. Put oven back into
operation. If function error
code repeats, disconnect power
to the oven and call for service.
(continued nextpage)
m
_o
.d
19