Filter
Top Products
SOLD
DISK
MOD~E
How to Insert the Module
1.
Be sure the controls are turned
to
O=.
To install the module,
position the plug to the outside
wall of the cooktop.
2. Slide the module toward the
oudet
in the side of the cooktop
until the plug is pushed
dl
the
way in.
3.
bwer
the
imide
edge of the
modde into the cooktop until
it is flush with the cooking
stiace.
How to Remove the Module
.
1.
Be sure the controls are turned to
0~
and the solid
3. To unplug, hold the module by the front and back
disk surface units are cool before attempting to
edges and slide toward the center of the cooktop.
remove the module.
Lift out when unplugged.
2. Lift up the tab at the
hside
edge of the modtie
untti
4. If you are storing moddes, do not stack them or
the base clears the opening at the side of the cooktop.
store other materials on top of them. This could
damage the surface of the
moddes.
—
Before Using Your Solid Disk Module for the First Time
The top working surface of solid disk surface units
THE
S~ACE
UNIT’S
PROTECTI~
have a protective coating which must be hardened
COA~NG
WST
BE
HARDENED TO
before using the surface units for the first time. HELP PROTECT THE
SU~ACE
UN~
To harden this coating, the surface units should be
THROUGHOUT ITS LIPE.
briefly heated without a pan for about 5 minutes at the
HI setting. Otherwise the
mating
wfll
stick to the pan.
There wi~ be some smoke and odor; this is
no-.
Heating of the surface units
wtil
change the staidess
steel
surfam
unit trim rings to a gold color.
—
12