Filter
Top Products
How to
hseti
the Module
1.
Be sure the controls are turned
to
0~.
To install the module,
position the plug to the outside
wdl
of the cooktop.
2.
Slide the modtie toward the
outiet
in the side of the cooktop
until the plug is pushed
dl
the
way in.
3. Lower the inside edge of the
module into the cooktop
untti
it
is flush with the cooking
surface.
How to Remove the Module
1.
Be sure the controls are turned to
0~
and the
radiant surface units are cool before attempting to
remove the module.
2. Lift up the tab at the inside edge of the module
until the base clears the opening at the side of
the cooktop.
3.
To unplug, hold the module by the front and back
edges and slide toward the center of the cooktop.
Lift out when unplugged.
4. If you are storing modules, do not stack them or
store other
matends on top of them. This could
damage the surface of the
modties.
—
&neml
Information About Radiant Modules
The radiant module features heating coils beneath a
smooth glass
@rarnic
surface. The two surfaces units
are shown by
outiines
on the glass.
●
When a surface unit is activate&
cofls
beneath the
surface unit radiate heat through the glass to the
mohare.
The red glow of the
cofis
wdl
be instantly
visible through the glass. It
wi~
take the
surfam
unit
a few moments to heat up. The
cofi
cycles on and off
to maintain your selected control setting. The coils
have temperature limiters to prevent runaway
temperatures.
●
Use the same cookware that
you would use with
solid disk surface units.
●
If you are storing modules, do not stack them or
store other
matends
on top of
them
as damage to
the glass ceramic surface of the radiant module is
likely. Be careful not to damage or bend the
electrid
plug.
●
Do not let pots boil dry. Overheated metal can
bond to glass module.
A
overheated copper pot
wfil
leave a residue that will permanently stain
the
modde.
●
Sliding
rdurninum
cookware across the glass
may
leave
meti
marks. These
meti
marks
wfll
appear
as small scratches. They can be removed with Cook
Top Cleaning
Creme
and a razor scraper.
●
When a surface unit is turned on, the surface unit
can be seen glowing red within a few
semnds.
The
red
@ow
will turn on and off (cycling) to maintain
the selected heat setting. With poor cookware, you
wdl
see frequent cycling of the unit off and on.
Goo@
flat cookware will minimize the cycling.
●
It is safe to place hot cookware from the oven or
surface on the glass ceramic surface when the
surface is cool.
—
16