GE JSP60GN Range User Manual


 
Radiant Module
Cleaning of
glass
ceramic
is different from cleaning
a
r=
standard porcelain finish.
\>-
To maintain
and
protect the
\
— ./-” -
surface of your new
glass
ceramic
module follow these basic steps.
DAILY CLEANING:
Use
only Cook Top Cleaning Creme on Glass
Ceramic.
For normal, light soil:
1.
Rub
a
small
amount of Cook Top Creme onto
soiled area using
a
dry paper towel. Wipe until
all
soi]
and creme
are
l“emoved.
F1-equent
cleaning
leaves
a
protective coating of silicone which is
Special Care:
Sugary spillovers (such
as
jellies, fudge, candy
syrups) or melted plastics can cause pitting of the
surface
of
your module unless the spill is removed
while still hot.
Special care should be taken when
removing hot substances.
Follow these instructions
carefully and remove soil while spill is still hot.
1.
Turn
off
all surface units affected by the spillover.
Remove hot utensils.
2. Wearing an oven mitt, hold the razor
4
---
scraper at a
30°
angle
to
the module
““;
;.
-
and scrape the hot spill to a cool area
2,+.,
outside the surface unit. Be sure to use
y’
a new, sharp razor scraper.
Do
not use
a dull
or
nicked blade.
essential in preventing scratches and abrasions.
2. Clean surface with Cook Top Cleaning Creme after
3. With the spill in a cool area, use a dry paper towel
each use.
For heavy, burned on soil:
1.
Apply a few drops
of
Cook Top Cleaning
Creme to
the (cool) soiled area.
to remove-any excess. Any
spillover”r~mai
ning
should be left until the surface of the cooktop has
cooled. Do not continue
to
use the soiled surface
unit until all of the
spillover
has been removed.
Follow the steps under Heavy Soil to continue the
cleaning
t3rocess.
2. Using a dry paper towel, rub creme into the burned
on
area.
3.
Carefully scrape remaining soil with razor scraper.
Hold scraper at 300 angle against the ceramic surface.
4. If any soil remains, repeat the steps listed above.
For additional protection, after all soil has been
removed, polish the entire surface with the Cook
Top Cleaning Creme.
NOTE:
Using a razor scraper will not damage
the surface if
the
30°angle is maintained.
Store the razor scraper
out of reach of children.
Be sure to use a new, sharp
razor
scraper. Do not use
a dull or nicked blade.
-.
General Information:
As the Cook Top Cleaning Creme cleans, it leaves
a protective silicone coating on the
module
surface.
This coating helps to prevent build-up of mineral
deposits (water spots) and will make future cleaning
easier. Dishwasher detergents remove this protective
coating and therefore make the cooktop more
susceptible to staining.
PRECAUTIONS:
Most cleaners contain ammonia, chemicals and
abrasives
which can damage the surface of your
cooktop.
Use only the Cook Top Cleaning Creme
for proper cleaning and protection of your glass
ceramic surface.
If you slide aluminum or copper cookware across
the surface of your cooktop, they may leave metal
markings which appear as scratches. If this should
happen, use the razor scraper and Cleaning Creme to
remove these markings. Failure to remove these
residues immediately may leave permanent marks.
s
If pots with a thin overlay of aluminum, copper, or
enamel are allowed to boil dry, the overlay may
bond with the glass ceramic and leave a black
discoloration. This should be removed immediately
before
heating again or the discoloration
may
be
permanent.
0
Use of window cleaner may leave an iridescent film
on the cooktop. Cook Top Cleaning Creme will
remove this discoloration.
Water stains (calcium deposits) are removable
using Cook Top Cleaning Creme or
fu!l
strength
white vinegar.
(continueci
next
ixzge)
35