Filter
Top Products
Light Bulb Replacement
Cooktop
Light
Oven Light
REMOVE. SCREW
plug.
plug. Remove the top grill by
Remove screw on right side of
taking out the 2 screws that hold it
light compartment cover and lower
in place.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
To replace
cooktop
light, first
disconnect power at main fuse or
To replace
your oven light, first
disconnect power at main fuse or
wire with a
groun~in~
plug. The
circuit breaker panel or pull
circuit breaker panel or pull
plug must be plugged into an outlet
that is properly installed and
grounded.”(Fig.
1)
cover until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
Next, remove the single screw
located above door near center of
oven that secures
light
housing.
adhesive seal by
gen~ly
unscrewing
Replace burned-ou~bulb with-a
the bulbs. Replace with 40-watt
30-watt incandescent bulb,
incandescent-bulbs available from
your supplier. High intensity
40-
watt bulbs, which are available in
supermarkets and hardware stores,
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
vailable
from your supplier.
Clean off the
grease
and dust on
WARNING–Improper
use of the grounding plug
~an
result in a risk of electric shock.
Fig. 1
ENSURE PROPER
GROUND EXISTS
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is your
personal responsibility and
obligation to have it replaced with
hood surfaces
~ften.
Use a solution
a pr;perly grounded three-prong
of warm water and detergent.
wall receptacle.
About 1 tablespoon of ammonia
Do not under any circumstance
may be added to the water. Take
cut or remove the third (ground)
care not to touch the filters and
prong from the power cord.
enamel surfaces with this solution;
Do not use an adapter plug with
ammonia
will
darken metal.
this appliance.
Do not use an extension cord
with this appliance.
21