Filter
Top Products
LIGHT BULB REPLACEMENT
Cooktop Light/Night Light
To replace
combination
cooktop light/
night light, first
disconnect
power at main
fuse or circuit
breaker panel
or pull plug.
REMOVE SCREW
Remove screw on right side of light compartment
cover and lower cover until it stops.
Be sure bulbs
to be replaced
are cool before
removing.
Break the
adhesive seal
by gently
unscrewing the
bulbs. Replace with 40-watt incandescent bulbs
(WB02X4253) available from your GE supplier.
t High intensjLy__4.._wattbulbs (40S 1 1N/1),_w_hichare
"_va-gil-fiblein superm_ketgafidhar-crw-ai'E _toresl
[._nay also be used for replacements. Raise light
compartment cover and replace screw. Connect
electrical power to microwave oven.
Oven Light
To replace your oven light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold
it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
(WB02X4235), available from
your GE supplier.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
29
e