Filter
Top Products
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
OVEN WILL NOT COME
ON
CONTROL PANEL
LIGHTED,YET OVEN
WILL NOT START
"PROBE" APPEARS
ON DISPLAY
FLOOR OF THE
OVEN IS WARM,
EVEN WHEN THE
OVEN HAS NOT
BEEN USED
POSSIBLE CAUSE
• A fuse in your home may be blown or the circuit breaker tripped. Replace fuse
or reset circuit breaker.
• Unplug your microwave oven, then plug it back in.
• Make sure 3-prong plug on oven is fully inserted into wall receptacle.
• Door not securely closed.
• START pad must be touched after entering cooking selection.
,Another selection entered already in oven and CLEANOFF pad not touched
to cancel it.
,Make sure you have entered cooking time after touching TIME COOK I & II
pad.
• CLEAR/OFF pad was touched accidentally. Reset cooking program and touch
START pad.
• Make sure you have entered a temperature after touching TEMP COOK/HOLD
pad.
• Make sure you have entered a code number after touching AUTO ROAST pad.
.Probe has been forgotten or not seated properly in oven wall when using Temp
Cook/Hold or Auto Roast function.
• The cooktop lamp is located directly below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is normal.
All these things are normal with your microwave oven:
• Steam or vapor escaping from around the door.
• Light reflection around door or outer case.
• Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
• Dull thumping sound while oven is operating.
• Some TV-Radio interference might be noticed
while using your microwave oven. It's similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
If you need more help...cail, toll free: GE Answer Center"/800.626.2000/consumer information service
32