Filter
Top Products
Cooktop
Li@t/Ni@t Li@t
Oven Li@t
REMOVE SCREW
To replace combination
cooktop
light/night light,
first
disconnect
power at main fuse or circuit
breaker panel or pull plug.
To
replace
your oven light, first
disconnect power at main fuse
or circuit breaker or
pull
plug.
Remove screw on right side of light
Remove the top grill by
taking
out
compartment cover and lower cover
3 screws that hold it in place.
until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs
(WB2X4253)
available from your GE supplier.
High intensity 40-watt bulbs
(40SllN/1) which are available in
supermarkets and hardware stores
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
I
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt GE bulb
(WB2X4235)
available from your GE supplier.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
wARNING-Improper
use of the grounding plug can result
in a risk of electric shock.
-~
QQ
%
/
%
INSURE PROPER
GROUND EXISTS
Fig. 1
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
detergent solution. About 1
tablespoon of ammonia may be
added to the water. Take care not
to touch the filters and enameled
surfaces with this. Ammonia will
tend to darken metal.
Clean
off the grease and dust on
your’ personal responsibility and
hood surfaces often. Use a warm
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord with
this appliance.
29