GE JVM172H Microwave Oven User Manual


 
Cooktop
Light/Night Light
Oven Light
REMOVE SCREW
To
replace combination
cooktop
light/night light, first disconnect
power at main fuse or circuit
breaker panel or pull plug.
With smoke & spatter shield in
the OUT position, remove screw
on right side of light compartment
cover and lower cover until it stops.
I
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs
(WB2X4253)
available from your GE supplier.
High intensity 40-watt bulbs
(40SllN/1) which are available in
supermarkets and hardware stores
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
To
replace your oven light,
first
disconnect power at main fuse
or circuit breaker or pull plug.
Remove the top grill by taking out
3 screws that hold it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt GE bulb
(WB2X4235)
available from your GE supplier.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING-improper
use of the grounding plug can result
in a risk of electric shock.
INSURE PROPER
GROUND EXISTS
Fig. 1
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Clean
off the grease and dust on
hood surfaces often. Use a warm
detergent solution. About 1
tablespoon of ammonia may be
added to the water providing it does
Do not under any circumstance
not touch the filters or enameled
cut or remove the third (ground)
surfaces because ammonia tends
prong from the power cord.
to darken metal. Wash the smoke
& spatter shield with a warm
Do not use an adapter plug with
detergent solution.
this appliance.
Do not use an extension cord with
this appliance.
29