Filter
Top Products
Proper care and cleaning are important so your range
will give you efficient and satisfacto~ service.
Follow these directions carefully in caring for your
cooktop to assure safe and proper maintenance.
BE SURE T~T ELECTWC POWER IS OFF
BEFORE CLEAMNG Am PART OFT=
RANGE.
Removalof PackagingTape
The safest way to remove adhesive left from packing
NOTE: The plastic tape that is not removed from the
tape on new appliances to assure no damage is done
chrome trim on oven parts cannot be removed if
to the finish of the product is an application of a
baked on.
household liquid dishwashing detergent, mineral oil
or cooking oil. Apply with a soft cloth and allow to
soak. Wipe dry and then apply an appliance polish
to thoroughly clean and protect the surface. This
procedure is also safe for the face of microwave doors
and other plastic and Lexan parts.
Glass Top
Wipe the glass cooktop clean after each use. Use an
all-purpose, non-abrasive cleaner. Do not use a dish
towel or sponge to wipe up the cooktop. They may
leave a film of detergent which can discolor your
cooktop when heated. If this happens, remove the film
with the recommended cleaner. We recommend that
you use paper towels or a clean cloth which is used
only for cleaning the cooktop.
For burned on spillover:
● Remove excess soil with a razor scraper.
Wearing an oven mitt, hold the scraper at a 30°
angle to the cooktop and scrape off the soil. Be sure
to use a new, sharp razor scraper. Do not use a dull
or nicked blade.
NOTE:
QUsing a razor scraper will not damage the surface if
the 30° angle is maintained. Store the razor scraper
out of reach of children.
● Scrub the glass cooktop with an all-purpose, non-
abrasive cleaner, such as Bon Arni@brand, or with a
cooktop cleaning creme. Rinse well and wipe dry.
Cook Top Cleaning Creme is available at your GE
Appliance and Parts Stores, Part No. WB64X5020.
● Never use abrasive scouring pads or powders on
the glass cooktop. Plastic mesh pads such as Dobie@
brand may be used.
Solid Disk Sutiace Uni@
The solid disksurface units are made of high
strengthcast-ironalloy.
The surface has a heat-resistantcoating to preserve
the surface of the unit. After the unit cools, any
boiled-overmaterialon them should be removed as
soon as possiblewith a slightlydamp cloth. The surface
unit shouldthen be dried by switching on for a few
minutes.After it cools,wipe lightly with cookingoil.
Clean very dirty solid disksurface units with a Uttle
cleaning powder (such as Comet@cleanser) or with a
scouringpad .
The matte black surface can be maintainedby
treating it periodicallywith the Cello Electrol@
polish which is availablefrom your GE supplier.
Use the applicatorto apply a very thin coating of the
polish to the entire unit surface.Turn the surface unit
on high for several minutesto bake thepolish to the
unit. When the unit is cooled,rub lightly with a cloth or
paper towel to remove any excess polish.Before next
use, bum off the surfaceunit by means of a short
preheatingperiod. A slight amountof smoke and odor
will occur.
Do not use covers over the sotiddisk surface units.
A surfaceunit turned on while the cover is in place can
permanency damagethe cooktop. Coverscan also trap
moisturewhich may cause the units to rust.
28