Filter
Top Products
Suflace Light and Starter (on some models)
Do not touch the btib when it is hot or with wet
hands. Never wipe the tight area with a wet cloth.
Electrical power must be shut off if you have to
replace a broken bulb.
To replace the btib:
1. flip the front of the hinged canopy up.
2. Remove the fluorescent light bulb. Replace the
bulb with one of the same length and wattage.
3. hwer the canopy.
To replace the stirter:
1. Open the canopy and remove the bulb as
explained above.
2. Grasp the starter, turn it counterclockwise, about
one quarter turn and lift out. Replace with one of
the same wattage.
3. Reposition the bulb and lower the canopy.
Canopy
Bulb
Statier
A
=::
_.
.\
ControlPanel and mobs
It’s a good idea to wipe the control panel after each
use of the oven. Clean with mild soap and water or
vinegar and water, rinse with clean water and polish
dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven cleansers
on the control panel—they will damage the finish.
A 50/50 solution of vinegar and hot water solution
works well.
The control knobs may be removed for easier
cleaning.
Before removing the knobs for clwning, please note
that the knobs on the left side and the knobs on the
right side are in the proper 0~ position. When
replacing the knobs, check the 0~ position to insure
proper placement.
To remove the knob, pull it straight off the spring
clip. If it is difficult to remove, place a thin cloth (like
a handkerchief or a piece of string under and around
the knob edge and pull up.
The knob stem has a groove in each side. The groove
on one side has a spring clip. The other groove is
clear (see illustration). Check the inside of the knob
and find the molded rib. Replace the knob by fitting
the molded rib inside the knob into the clear groove
on the stem. Wash the knobs in soap and water or a
ClearGroove
in Stem
GlassSufiaces
Painted Sufiaces
Toclean the outside glass finish,
Painted surfaces include the
use a glass cleaner. Rinse and
outside oven door, sides, control
polish with a dry cloth. Do not
panel and drawer front. Clean
allow the water or cleaner to run
these with soap and water or a
~owninside openings in the top of
vinegar and water solution.
the oven door while cleaning.
Do not use commercial oven
cleaners, cleansing powders,
steel wool or harsh abrasives on
any painted surface.
MetalParts
Do not use steel wool, abrasives,
ammonia or commercial oven
cleaners. To safely clean surfaces;
wash, rinse and then dry with a
soft cloth.
(continuednextpage)
29