GE PD900 Range User Manual


  Open as PDF
of 16
 
1
Before You Begin
Read these instructions carefully and completely.
•IMPORTANT—Savethese
instructions for local inspector’s use.
•
IMPORTANT—Observeall
governingcodesandordinances.
•NotetoInstaller—Besuretoleavethese
instructions with the consumer.
•NotetoConsumer—Keepthese
instructions for future reference.
•Properinstallationistheresponsibility
of the installer and product failure due
toimproperinstallationisNOTcoveredunder
the warranty.
•NOTE—Thisappliancemustbeproperly
grounded.
•
ATTENTIONINSTALLER
Allelectricdrop-inrangesmustbehardwired
(directwired)intoanapprovedjunctionbox.A
plug and receptacle is NOT permitted on these
products.
Ifyouhavequestions,call1.800.GE.CARESorvisitourwebsiteat:
GEAppliances.com
Self-CleaningRadiant
ElectricDrop-InRange
Installation
Instructions
JDP47, JD968, JD900, PD900, PD968
Materials Needed
Junction Box
Wire NutsStrain Relief Clamp for
1/2” conduit
Parts Included
Lower Trim
4 Screws
2 Shoulder Screws (for
stop device)
Tools You Will Need
1/8” Drill Bit and Electric
or Hand Drill
Phillips Screwdriver
Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Standard Screwdriver
Pencil
Safety Glasses
Hammer
31-10622-3 02-10
next