2
IMPORTANTSAFETYINSTRUCTIONS
Installation Instructions
ForYourSafety
•Allrough-inandspacingdimensionsmustbe
met for safe use of your range.
•Toreducetheriskofburnsorrewhen
reaching over hot surface elements, cabinet
storagespaceabovethecooktopshouldbe
avoided. If cabinet storage space is to be
providedabovethecooktop,theriskcanbe
reducedbyinstallingarangehoodthatsticks
out at least 5” beyond the front of the cabinets.
Cabinetsinstalledabovethecooktopmustbe
no deeper than 13”.
•Besureyourapplianceisproperlyinstalledand
groundedbyaqualiedtechnician.
We recommend you have the electrical wiring
andhookupofyourrangeconnectedbya
qualiedelectrician.Afterinstallation,havethe
electrician show you where your main range
disconnect is located.
Checkwithyourlocalutilitiesforelectricalcodes
which apply in your area. Failure to wire your
range according to governing codes could result
in a hazardous condition. If there are no local
codes, your range must be wired and fused to
meet the requirements of the National Electrical
Code,ANSI/NFPANo.70–LatestEdition.Youcan
get a copy by writing:
NationalFireProtectionAssociation
BatterymarchPark
Quincy,MA02269
EectiveJanuary1,1996,theNational
Electrical Code requires that new, but not
existing, construction utilize a four-conductor
connection to an electric range. When installing
an electric range in new construction, a mobile
home, recreational vehicle or an area where
local codes prohibit grounding through the
neutral conductor, follow the instructions in the
sectiononNEWCONSTRUCTIONANDFOUR-
CONDUCTORBRANCHCIRCUITCONNECTION.
Youmustuseathree-wire,single-phase
A.C.208Y/120Voltor240/120Volt,60hertz
electrical system. If you connect to aluminum
wiring, properly installed connectors approved
for use with aluminum wiring must be used.
WARNING:Forpersonalsafety,
removehousefuseoropencircuit
breakerbeforebeginninginstallation.
Failuretodosocouldresultinserious
injuryordeath.
Rating Plate
Location
Electrical
Requirements
This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded branch
circuit,protectedbyacircuitbreakerorfuse
having amperage as noted on rating plate.
(Rating Plate is located behind the oven door
on the range.)