10
Installation Instructions
(Continued on following page)
StandardInstallationInstructions cont.
D
Carefullymarkthecabinetforthe
location of the stop screws. Drill 1/8”
pilot holes into the cabinet, each side of
therange.(Makesurenottodrillentirely
through the cabinet wall.) Carefully turn
the shoulder screws into the pilot holes
until they are tight.
InstallStopScrew
These screws prevent the range from
sliding out of position during operation.
Placing the Range into the
Opening(Continued)
D2 D3
Placing the Range into the
Opening
It is suggested that two people lift the
range into place, carefully setting the
sidemetalangesundertheglasson
the edges of the countertop opening.
The protective channels must be in
place (if supplied) during this operation.
D3
Countertop
Cabinet
Range
LiftandSlideRange
onCountertop
Countertop
GapApprox.4”
GapApprox.4”
RemovetheProtectiveChannels
(ifprovided)
Carefully remove the protective channels
fromthesidesoftheglasscooktop.This
may require a slight lifting of the range to
remove the weight of the range from the
protective channels.
D4
RemoveProtectiveCoverFrom
BothSidesAfterRangeIsInCabinet
ProtectiveCover
GlassCooktop
Carefullyslidetherangetowardthebackofthe
opening. Stop pushing the Range when there
isstilla4”gapatthefrontbeforeushingthe
Range with the countertop.