Filter
Top Products
24
ADJUSTING THE HEIGHT BETWEEN THE DOORS
The adjuster in the Fresh Select Zone can be used in the same way.
NOTE
If the Arctic Select Zone Door is lower than the Fresh Select Zone Door.
1) Locate the height-adjuster (➀) in the Arctic Select Zone.
Unscrew the four phillips screws (➁) slightly to loose the door.
2) Unscrew the adjuster-phillips screw (
➂
) two times turns to rotate the adjuster.
3) Find the best adjuster-level to align the door gap.
After adjustment, tighten the screws (
➁ & ➂
) in reverse order.
adjustment part
Arctic Select Zone
Fresh Select Zone
- Rotate down the adjuster-face with
+
2.0 number to reduce the door gap.
- The number of the adjuster to rotate depends on the gap.
Arctic Select Zone Door Fresh Select Zone Door
gap
➁
➀
➂
CASE) The gap is about 2mm (0.08inch) as shown below.
reference plane