Filter
Top Products
INSTALLATION OF THE WATER DISPENSER LINE
35
INSTALLATION INSTRUCTIONS
1) As shown, open the cartridge cover by pulling and pushing up at the front
2)
Remove the water filter from the box then position the arrow of the cartridge in line with the cartridge cover.
3) Insert the filter as shown and Push until you hear a click.
4) Close the filter cartridge cover.
Install the water filter.
The water filter cartridge is located at the upper right corner of the Fridge compartment.
When the display in the control panel indicates “filter change”, it is recommended that the filter cartridge be changed.
NOTE
Under the high water pressure, water may drip from the water filter’s case.
If you put the small tray beneath the filter cover hole, it will be helpul to clean the shelf.
NOTE
After changing the filter cartridge, throw away the first six glassfuls of water to flush out trapped air.
Do not push and pull the water cartridge repeatedly, as water pressure will make the water spurt.
NOTE
Be sure to align the filter cartridge hook and housing.
NOTE
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the
water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been empty.
- At this time, check for any possible leakages at the join point in the water line.
After securing the water line, move the refrigerator to the required location.
Once the refrigerator is in position, do not move possibly.
CLIP A
WATER LINE
Secure the water line.