Filter
Top Products
37
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
3)
Important Facts About Your Dispenser :
Do not add ice from trays or bags to the storage bin. It may not crush or dispense well.
Avoid overfilling glass with ice and use of narrow or extra-tall glasses. Backed-up ice can jam the
chute or cause the door in the chute to freeze shut. If ice is blocking the chute, poke it through with
a wooden spoon.
Beverages and foods should not be quick-chilled in the ice storage bin.
To keep dispensed ice from missing the glass, put the glass close to, but not touching, the dis-
penser opening.
Some crushed ice may be dispensed even though you selected CUBES. This happens occasionally
when a few cubes accidentally get directed to the crusher.
After crushed ice is dispensed, some water may drip from the chute.
4) Water Supply to the Icemaker :
The icemaker must be connected to a cold water line.
5) Start the Icemaker :
Set the type of ice to the "Cubed Ice" or "Crushed Ice" position.The icemaker will not begin to oper-
ate until it reachs its operating of -12°C or below. It will then begin operation automatically if the type
of ice is in the "Cubed Ice" or "Crushed Ice" position.
•
If there is no water supply, turn off the icemaker to save energy.
•
In lower water pressure conditions, the water valve may turn on up to 3 times to make sure enough
water reaches the icemaker.
•
Allow the appliance to stand for 2hours after installation.
NOTE
Use only the ice maker provided with the refrigerator.
WARNING