Filter
Top Products
12
Customer Service Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Leveling
Your refrigerator comes with adjustable rollers and
adjustable legs.
Either rollers or legs should be set so
the refrigerator is firmly positioned on the floor and
the front is raised just enough that the doors close
easily when opened about halfway.
To adjust the rollers,
tilt the base grille out
exposing the adjustment screws. Using an
adjustable wrench, turn the two front roller
adjusting screws counterclockwise to raise the
refrigerator, clockwise to lower it.
Adjustable legs
are located at the front corners.
Turn the adjustable legs clockwise to raise the
refrigerator, counterclockwise to lower it.
Preparing to install the refrigerator.
Turn adjustment leg clockwise
to raise refrigerator
Base Grille
Adjustable
Roller
Adjustable
Leg
Turn adjusting screw
counterclockwise to raise
refrigerator
Tilt top out
Read these instructions completely and carefully.
Refrigerator Location
Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Install it on a floor strong enough to support it
fully loaded.
Clearances
Allow the following clearances for ease of
installation and proper air circulation.
Sides 0″ (0 mm)
Top 1″ (25 mm)
Back* 1
1
/4″ (32 mm)
*Metal cover on back may touch wall.
If refrigerator is to be installed against a wall on the
hinge side, allow a minimum of 1
3
/4″ (45 mm)
between the wall and the side of the refrigerator to
allow for door and handle clearance.
Packaging Tapes
Remove all packaging tapes and peel-off films.
These tapes were added to secure and protect
your refrigerator during transit.