Filter
Top Products
14
Customer Service Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Reversing the door swing.
Reversing the Hardware
Transfer Bottom Hinge Bracket to the Left
(For freezer swing door models only.)
Pull out grille 1″ (25 mm) and set it down on the
floor to gain access to the hinge bracket screws.
Using a 3/8″ socket, remove the hinge bracket,
screws, plastic washer and spacer shim from the
bottom right side of the cabinet.
Remove plug button and screw from the
bottom left side of the cabinet and install at
the bottom right.
Reinstall the spacer shim, hinge bracket,
screws and plastic washer to the bottom left
side of the cabinet.
d
c
b
a
Transfer Center Hinge Bracket to the Left
Remove the center hinge bracket and shim by
removing the three screws.
NOTE:
Keep these
screws with the hinge bracket. They are longer
screws and will be used when installing the hinge
on the other side.
Remove the three painted screws and take
washers from the center left side of the cabinet.
Screw them into the holes on the right side,
which were uncovered in Step “a” above.
Place the center hinge bracket and shim over
the holes at the center left side of the cabinet.
Insert the three screws that were removed with
the center hinge bracket in Step “a” and
tighten securely.
Do not install the hinge pin yet.
c
b
a
Transfer Top Hinge to the Left
Interchange hinge and shim at top right with two
plug buttons at top left of cabinet. Do not tighten
screws on hinge side at this time.
Bottom Right
Plastic
Washer
Bottom Left
Center Right
Center Left
Plastic
Washer
Read these instructions completely and carefully.