Filter
Top Products
21
ZPF75 Custom Panel Kit
3/4" Thick Custom Door Panel
Step 5
Install
Assembled
Door onto
Dishwasher
Note:
One person should hold the door while the other installs
screws to prevent the door assembly from falling.
• Check to be sure that foam inserts are in
place.
• Hold the assembled door to dishwasher
inner door and slide up against control
panel. The control panel has posts that
should engage the 2 holes in the top of the
metal panel.
• Install the original center screws and
o-rings.
Note:
Center screws and o-rings must be securely fastened to
prevent leaks.
• Install original screws to sides of inner door
frame, 3 each side.
The additional weight of the custom panel
may require that the heavy door springs be
installed.
Test Door Balance
• With one hand under the door, slowly open
the door fully.
• Open and close the door to check for
proper balance. Correct door balance
should prevent the door from raising by
itself from a full open position and prevent
the door from falling heavily.
• If the door falls heavily, damage will occur
from repeated use.
• Install one or both new springs provided.
Install New Springs:
• Close and latch the dishwasher door.
• Locate door spring on left side of dish-
washer.
• Disengage the push rod guide by pushing
down on the guide and slowly pulling the
guide out of the mounting position.
• Carefully release the tension on the spring
and remove the push rod guide from the
rod.
• Remove the spring and replace with the
spring that has a yellow marking.
• Reassemble the push rod guide into the
original position.
• Test door balance.
• Install right side spring if needed.
Step 6
Install
Door
Springs
2 “O” Rings
Foam
Insert
Moisture Strip
Foam
Insert
Control Panel
Post Holes
Push
Rod
Guide