Filter
Top Products
22
ZPF75 Custom Panel Kit
3/4" Thick Custom Door Panel
Step 7
Install
Custom
Toekick
• Slip toekick slides into guides by pulling out
the metal tabs.
• Hold custom panel against toekick slides
and mark screw hole locations.
• Remove toekick and drill 1/8" pilot holes.
• Remove toekick slides and secure panel to
slides with 2 screws each. Use screws “X”. If
panels are 1/2" thick, use caution when
driving these screws.
• Insert the assembled toekick into the
support brackets by pulling out the metal
tabs.
• Carefully, slide assembly back until it is
aligned with adjacent cabinetry toekick.
• See product installation instructions to
reinstall the dishwasher.
• Carefully, hold the door and open fully.
Insure that door does not strike top of
toekick.
Pull Tab While Pushing toekick in
Screw X