Filter
Top Products
9
3. HEATED DRY— When selected, turns the drying heater and fan on for fast drying. This option
will extend the cycle by 30 minutes. When this is NOT selected, the fan will
turn on to dry your dishes without added heat—and energy is saved.
HEATED DRY is not available on RINSE ONLY.
4. WATER TEMP— This button provides extra heat options to increase water temperature for
optimum performance.
NORMAL This is the default setting—provides a wash and rinse with water temperatures
up to 131°F (55°C) in the NORMAL cycle and 145°F (63°C) in POTS &
PANS.
HIGH This water temp selection provides a wash and rinse with water temperatures
up to 135°F (57°C) in the NORMAL cycle and 155°F (68°C) in POTS &
PANS. Use this option for heavily soiled dishes. Cannot be used with RINSE
ONLY or CHINA CRYSTAL.
5. DELAY START—This option will allow you to delay the start time of any wash cycle except
RINSE ONLY for up to 6 hours.
• Select the delay start time you want by pressing the DELAY START button. Multiple pressing
will alternate the delay time between 2, 4 or 6 hours and OFF.
Start a
wash load
To start the dishwasher, close the door until it locks in place. The last used cycle will be displayed.
To begin this cycle, push the START button. To select a different cycle, push the desired Cycle
Selection and Option buttons, and then press the START button.
The door must be closed and latched into place to select a cycle or an option.
To interrupt/pause a cycle, press the selected cycle button. The Status Indicators will flash.
CAUTION: Be careful when opening the door; the hot steam that escapes when the door is
opened may cause injuries. Stand back as you open the door and allow the steam to
escape.
ATTENTION : Faites attention lorsque vous ouvrez la porte. La vapeur brûlante qui s’échappe
lorsque vous ouvrez la porte pendant un programme de lavage peut causer des
brûlures. Lorsque vous ouvrez la porte, reculez et laissez la vapeur s’échapper de
l’appareil.
To restart the wash process, close the door until it locks in place. Re-press the cycle button. There
may be a time delay of up to a few minutes, because the temperature inside the dishwasher needs to
stabilize before it starts the wash cycle. During this time the SENSING light will be on.
To cancel the cycle after it has started, press and hold the START/CANCEL button for 3 seconds.
The dishwasher will then drain and the cycle indicator lights will flash. At this point a new wash cycle
can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out after the
dishwasher drains. If you have selected a new wash cycle, remember to add more detergent to
the detergent compartment if required.
Control Panel/Operation — ZBD6400 & ZBD6500
Dishwasher