Filter
Top Products
14
Step 2
Install
Water Line
• Install optional water filter in the water line near the
refrigerator. A water filter is recommended in areas
where water supply contains sand or particles.
Installation instructions are packed with the filter.
• A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 20 and 120 p.s.i.
• Route 1/4″ OD copper or GE SmartConnect
™
tubing between house cold water line and the
water connection location.
• Tubing should be long enough to extend to
the front of the refrigerator. Allow enough to
accommodate bend leading into the water valve.
NOTE: The only GE approved plastic tubing is
supplied in the GE SmartConnect
™
Refrigerator
Tubing kits. Do not use any other plastic water
supply line because the line is under pressure at all
times. Other types of plastic may crack or rupture
with age and cause water damage to your home.
GE SmartConnect
™
Refrigerator Tubing Kits are
available in the following lengths:
2′ (.6 m) WX08X10002
6′ (1.8 m) WX08X10006
15′ (4.6 m) WX08X10015
25′ (7.6 m) WX08X10025
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
• Install a shut-off valve between the icemaker
water valve and cold water pipe in a basement or
cabinet. The shut-off valve should be located where
it will be easily accessible.
• Turn on the main water supply and flush debris
from the line. Run about a quart of water through
the tubing into a bucket. Shut off water at the
shut-off valve.
NOTE: Saddle type shut-off valves are included in
many water supply kits, but are not recommended
for this application.
Floor
Waterline Tubing
NOTE: Commonwealth of Massachusetts
Plumbing Codes 248CMR shall be adhered to.
Saddle valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
Installation
36″ Refrigerators, Freezers