Filter
Top Products
17
Step 9
Check
Power
• Check to make sure power is on by opening the
door to see if interior lights are on.
If you are using a 3/4″ thick custom panel, SKIP THIS
STEP. See Dimensions and Specifications for grille
panel sizes. Order ZKTR36LH or ZKTR36RH and follow
the installation instructions packed with the kit.
The grille panel frame is factory assembled for an
84″ installation height. If installation height varies,
order ZGC2 trim kit which provides optional side trim
pieces for 83-1/2″ and 84-1/2″ heights.
Cut 1/4″ thick custom panel to fit the frame,
35-1/8″ wide, 8″ deep (for an 84″ installation).
To insert custom grille panel into the frame:
• Remove screws (2 on each top corner) and “L”
brackets on each side.
• Slide panel into the frame and reassemble.
• Mount the grille panel by dropping into slots on the
case trim.
• For shipping purposes, the top case trim is secured
at 84″ installation height.
To raise case trim to 84-1/2″ or to lower to 83-1/2″
installation height:
• Loosen 2 screws on both sides and raise the top or
lower case trim to meet soffit height or to the top of
adjacent cabinets.
• Tighten all 4 screws.
Step 10
Mount
Top Grille
Panel
IMPORTANT: Maintain 1-1/2″ min. gap between top
of doors and bottom of panel frame.
1-1/2"
min.
gap
Screws
Top Case Trim
Raise To
Installation
Height
Step 8
Install 1/4″
door panels
If you are using a 3/4″ thick custom panel, SKIP THIS
STEP. See Custom Panel Dimensions pages for panel
sizes with ZKTR36LH or ZKTR36RH trim kit and other
kits. Refer to trim kit instructions in this booklet.
• Open door to 90° stop. Remove the Phillips head
screws from the aluminum trim door handle.
• Remove handle. Retain all screws and handle.
• Slide custom panel into the door trim.
• Replace door handle and secure with original
screws.
Installation
36″ Refrigerators, Freezers