Filter
Top Products
39
Step 9
Install
Soffit
Vent Top
• Separate the top and hinge side trim pieces by
removing side screws. Discard top piece, retain
screws.
• Install one end piece to unified top piece with
2 original screws.
• Slip end of rubber dust gasket into end of top
unified piece and slide trim towards the center.
Engage the second piece of gasket and continue
sliding trim until even with opposite ends.
• Reinstall end pieces to case trims. Push top piece
up against soffit or to installation height. Tighten
screws on both sides.
• Whenever possible, place a level on the top trim.
Adjust side trims until entire grille frame is level.
Slip Second Dust
Gasket Into Trim
Slip Dust Gasket
Into Trim On One End
Reinstall
Screws
• Secure the grille panel support to the back side
of the 3/4″ thick custom panel with #6 screws.
Be sure the lip of the support is over the top of
the wood panel.
• Install four of the six larger undercut screws so that
the top of the screws are 1/16″ from the surface of
the support.
• Attach the assembled panel to the grille opening
by inserting the four protruding screws into the
brackets on each side.
Back View
Grille Panel Support
Panel Support
Overlaps Top
Step 10
Secure
Custom Panel
To Support
NOTE: Use screws supplied with ZKTR36 Trim Kits.
1/16"
ZUG75 Trim Kit
Unified 3/4″ Custom Grille Panel Kit