Filter
Top Products
8
Status Indicator Lights
(indicators vary by model)
The Status display tells you what is happening while the dishwasher is in operation.
The lights will come ON, indicating the sequence of the dishwasher operation.
LOW DETERGENT Displayed when the Bulk Dispenser needs to be refilled with liquid or gel
automatic dishwasher detergent.
NOTE: If you are not using the Bulk Dispenser and and you want to turn
the LOW DETERGENT LED light off, press the ADDED HEAT pad 5 times within
3 seconds. You will hear 3 beeps; then the light will go off. You can turn the light
back on by pressing the ADDED HEAT pad 5 times within 3 seconds.
SENSING Displayed while the ExtraClean
™
Sensor is measuring the amount of soil and
temperature of water. The dishwasher will adjust the selected cycle to achieve
optimal performance.
ADD-A-DISH Displayed during prewash, indicating that dishes added now will still be cleaned.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle and enhancements are complete.
Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display
may adjust the remaining time while the Sensing light is on. The time displayed at the start of
each cycle may change from the factory setting as the unit customizes itself to actual home
usage. During a DELAY HOURS, the display will show hours of time remaining until the cycle starts.
START/RESET
START— After selecting the cycle and desired enhancements, press the START/RESET pad
one time to ready the dishwasher to begin the cycle. Close the door to start the
cycle or begin the DELAY HOURS countdown. When the cycle starts, the water
fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements.
If you don’t want to change the settings, simply press the START/RESET pad
one time to ready the dishwasher and close the door to begin the cycle.
NOTE: If the START/RESET light is flashing, the cycle has been interrupted.
Light will stop flashing after the dishwasher automatically pumps out the water.
Close the door to allow the water to pump out (this takes approximately
70 seconds). When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be
programmed. Make any new selections and press the START/RESET pad to begin
the new cycle.
RESET— Open the door slowly to prevent splash-out. Press the START/RESET pad
to cancel the cycle. Close the door. The dishwasher will pump out and turn off
after 70 seconds.
Clean— The CLEAN light is illuminated and a double beep will sound when the selected
cycle and enhancements are complete. You may remove the dishes at any
time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours
(depending on selected cycle) after the CLEAN light is illuminated to continue
drying the dishes. This can be stopped by opening the door and pressing
any keypad.
NOTE: To turn off the double beep indicator (or re-activate it if it was previously
disengaged), press the HEATED DRY pad 5 times within 3 seconds. A triple beep
will sound to indicate the end-of-cycle beep option has been toggled.
Dishwasher
Control Panel/Operation
7
8
9
10