Filter
Top Products
Grill Component
Component Cooktop System
18
Grease
collector
jar
Grill grate
Grill element
Drip pan
Grease
well
Electric receptacles
How to
assemble the
grill module
1. Be sure both the controls for the grill are
off (O).
2. Place the drip pan in the grease well first as
shown in the illustration in this section.
3. Grasp the grill element with both hands near
the plug. Keeping the element as nearly
horizontal as possible, push the plug firmly
into the electrical receptacles, to insure
complete contact. The element should lie flat
and rest on the ridges of the drip pan.
4. Place the grill grate into the opening in the
cooktop over the grill element.
5. Be certain the grease jar is clean and firmly
secured in the tube and lid assembly under
the porcelain enamel grease well.
Before
using your
grill
NOTE: The grill grate must be preconditioned
before using it for the first time. To
precondition, first wash it in soap and water.
Dry with a soft cloth. Then use a paper towel to
apply a small amount of no-stick cooking spray
to the grate. Remove excess with a clean paper
towel.
Use the grill for preparing meals with the
appearance and flavor of commercially char-
broiled meats. The grill must be very hot for this
type of cooking and smoke and spatter is to be
expected.
Be sure to use your venting system when grilling
to help minimize smoke.
You should have either a component downdraft
vent installed into the cooktop system or a high-
capacity vent hood.
Grill
control
Most cooking on the grill is done at the HI
setting. Each half of the grill component is
controlled separately.