Filter
Top Products
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
White film on inside Hard water minerals • To clean the interior, apply dishwasher
surfaces detergent to a damp sponge. Wear rubber
gloves. Do not use any type of cleanser
other than dishwasher detergent because
it may cause foaming or sudsing. Cascade
®
and Electrasol
®
Automatic Dishwashing
Detergents have been approved for use in all
Monogram dishwashers.
Dishes don’t dry Low inlet water • Make sure inlet water temperature is
temperature correct (see page 8).
Rinse agent dispenser • Check the rinse agent dispenser.
is empty
Dishwasher won’t run Fuse is blown, or the • Replace fuse or reset circuit breaker.
circuit breaker tripped Remove any other appliances from
the circuit.
Power is turned off • In some installations, the power to the
dishwasher is proved through a wall switch,
often located next to the disposer switch.
Make sure it is on.
Reboot your control • Turn off power to the dishwasher (at the
circuit breaker or wall switch) for
30 seconds; then turn back on.
Steam This is normal • Steam comes through the vent during
washing, drying and when water is being
pumped out.
Control panel Door latch may not be • Make sure the door is firmly closed.
responded to input properly seated
but dishwasher never
filled with water
Water valve may be • Make sure water valve (usually located
turned off under the sink) is turned on.
Dishwasher beeps This is normal • Close the door after opening it mid-cycle.
once every 15 seconds
This is a reminder that • Press ON/OFF to turn OFF the dishwasher.
the door has been left
open during operation
Beeping at the end of This is normal • The dishwasher will beep and the CLEAN
the cycle light will display at the end of the wash
cycle.
LOW RINSE AID light Rinse aid dispenser needs • This can only be turned off by filling the
is on to be refilled rinse aid dispenser with Jet-Dry
®
or
Cascade Crystal Clear
®
. See Refilling the
Rinse Aid Dispenser section.
Before You Call For Service
Dishwasher
17