Q. Why are my meats not turning out as brown
as they should?
A. In some areas, the power (voltage) to the oven may
be low. In these cases, preheat the broil element for
10 minutes before placing the broiler pan with
food in the oven. Check to see if you are using the
recommended shelf position. Broil for the longest
period of time indicated in the Broiling Guide.
Turn the food only once during broiling. You may
need to move the food to a higher shelf position.
Q. When broiling, is it necessary to always use
a grid in the pan?
A. Yes. Using the grid suspends the meat over the
pan. As the meat cooks, the juices fall into the
pan, thus keeping meat drier. Juices are protected
by the grid and stay cooler, thus preventing
excessive spatter and smoking.
Q. Should I salt the meat before broiling?
A. No. Salt draws out the juices and allows them to
evaporate. Always salt after cooking. Piercing
meat with a fork also allows juices to escape.
Turn the meat with tongs instead of a fork.
BROILING
Broiling is cooking food by intense radiant heat
from the upper broil element in the oven. Most
fish and tender cuts of meat can be broiled. Follow
these directions to keep spattering and smoking to
a minimum.
If the meat has fat or gristle around the edge, cut
vertical slashes through both about 2 inches apart. If
desired, the fat may be trimmed, leaving a layer about
1/8 inch thick.
Place the meat on the broiler grid in the broiler pan.
Always use the grid so the fat drips into the broiler
pan; otherwise the juices may become hot enough to
catch on fire.
Position a shelf on recommended shelf position as
suggested in the Broiling Guide. Most broiling is done
on C position, but if your oven is connected to 208
volts, you may wish to use a higher position.
Leave the door open to the
broil stop position. The door
stays open by itself, yet the
proper temperature is
maintained in the oven.
Turn the food using tongs only once during broiling.
Time the foods for the first side according to the
Broiling Guide.
Turn the food, then use the times given for the
second side as a guide to the preferred doneness.
NOTE: Broil will not work if the temperature probe
is plugged in.
Use of Aluminum Foil
You can use aluminum foil to line your broiler pan
and broiler grid. However, you must mold the foil
tightly to the grid and cut slits in it just like the grid.
Without the slits, the foil will prevent fat and meat
juices from draining into the broiler pan. The juices
could become hot enough to catch on fire. If you do
not cut the slits, you are frying, not broiling.
Questions and Answers
How to Set Your Oven for Broiling
1. Press BROIL HI/LO.
2. Press BROIL HI/LO again (alternates
between LO Broil and HI Broil).
3. Press START.
4. Press CLEAR/OFF when broiling
is finished.
CLEAR
OFF
START
BROIL
HI/LO
24