Filter
Top Products
OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the automatic oven timing functions to work properly.
The time of day clock cannot be changed during Delay Start. (It can be
changed during a regular bake or broil operation.)
Timer
You may program the timer to time cooking or other
household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
When the timer reaches “ :00,” the control will beep
3 times followed by one beep every 6 seconds until
KITCHEN TIMER ON/OFF is pressed.
The 6 second tone can be canceled by following the
steps in the Special Features of Your Oven Control
section under Tones at the End of a Timed Cycle.
How to Set the Timer
1. Press KITCHEN TIMER ON/OFF.
2. Press the number pads to set the time.
For example, to enter 2 hours and 45
minutes, touch 2, 4 and 5 in that order.
If you make a mistake, press KITCHEN
TIMER ON/OFF and begin again.
3. Press START.
After pressing START, “SET” disappears;
this tells you the time is counting down,
although the display does not change until
one minute has passed.
4. When time is up, the oven control
signals until you press KITCHEN
TIMER ON/OFF. Display then shows
the time of day.
NOTE: The minute timer is independent of all the
other functions and it does not control the oven.
The CLEAR/OFF pad does not affect the timer.
KITCHEN
TIMER
ON/OFF
START
KITCHEN
TIMER
ON/OFF
Power Failure
If a flashing time of day is in the display, you have experienced a power
failure. Reset the clock. To reset the clock, press CLOCK. Enter the correct
time of day by pressing the appropriate number pads. Press START.
(continued next page)
To Set the Clock
1. Press CLOCK.
2. Press the number pads the same way you
read them. For example, to set 12:34,
press the number pads 1, 2, 3 and 4 in
that order.
If number pads are not pressed within one minute
after you press CLOCK, the display reverts to the
original setting. If this happens, press CLOCK and
reenter the time of day.
3. Press START. This enters the time and
starts the clock.
To check the time of day when the display is
showing other information, simply press CLOCK.
The time of day shows until another pad is pressed.
START
CLOCK
9