Filter
Top Products
32
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM POSSIBLE CAUSE
“F–AND A NUMBER • This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
OR LETTER” FLASH hour. Place the oven back into operation.
IN THE DISPLAY
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
CONTROL SIGNALS AFTER • This is reminding you to press BAKE and then enter a bake temperature.
ENTERING COOKING TIME
• This is reminding you to enter a bake temperature after having pressed BAKE.
OR DELAY START TIME
DISPLAY GOES BLANK • The circuit breaker in your house has been tripped, or a fuse has been blown.
DISPLAY FLASHES • Power failure. Reset the clock.
UNABLE TO GET THE • BAKE and BROIL HI/LO must be pressed at the same time and held for
DISPLAY TO SHOW “SF” 2 seconds.
“PROBE” APPEARS IN • The probe is not inserted properly into the oven receptacle or food.
THE DISPLAY
• This is reminding you to enter a probe temperature after plugging in the probe.
“LOCK DOOR” FLASHES • Oven door not closed after self-clean cycle is selected.
“LOCKED DOOR” FLASHES • Door is still locked and you are trying to enter an oven cooking operation.
OVEN LIGHT DOES • The light bulb is loose or defective. Tighten or replace.
NOT WORK
• The pad operating the oven light is broken. Call for service.
OVEN WILL NOT SET A • Oven temperature is too high to set self-clean operation.
SELF-CLEAN CYCLE Allow the oven to cool to room temperature and reset the controls.
• The probe is plugged into the outlet in the oven. Remove the probe from the oven.
OVEN NOT CLEAN • Oven controls not set properly. See the Operating the Self-Cleaning
AFTER CLEAN CYCLE Oven section.
• Heavily soiled ovens require 4 to 5 hours of clean time.
• Heavy spillovers should be cleaned up before starting clean cycle.
DOOR WILL NOT • When the temperature has fallen below the locking temperature door can
OPEN AFTER be opened.
SELF-CLEAN CYCLE