Filter
Top Products
10
Installation
Microwave Oven
JX827WN
installation
• Install rear duct by inserting into bottom flange
between the oven and back of base pan.
– The rear duct should be as far to the left as
possible, between the base pan back flange and
the partition on the right side.
• Locate and use screws A.
• Drive one screw through the rear duct into the
partition in the base pan.
• Drive one screw into the rear duct side flange near
the lamp cover.
• Drive three screws through the base pan into the
rear duct bottom.
• Replace the screw removed from the top left to
complete the rear duct.
• The kit should be completely sealed to the micro-
wave oven in the back.
Caution:
Do not pinch
power cord.
• Plug the power cord into the wall receptacle.
• Gently slide the microwave oven assembly into the
cabinet opening, keeping it centered.
• Push to the back, allowing tongues of rear brackets
to slide through rear slots.
• Check to be sure oven is centered.
• Locate and use screws C.
• Drive two screws through the base pan front flange
through the holes drilled initially.
Screw A
Screw C