Filter
Top Products
Burner Assembly
CAUTION: DO NOT OPERATE THE
The electrode of the spark igniter is exposed
BURNER WITHOUT ALL BURNER PARTS
when the top of the burner is removed. Contact
CORRECTLY IN PLACE.
with an exposed igniter while a burner is being
turned on will cause a slight electrical shock.
The burner assemblies should be
washed regularly and, of course,
afier spillovers.
Turn all the controls off and wait
until all component parts are cool
before removing burner parts.
See the Care and Cleaning section.
Burner Cap
=————=.
.
fg?i!?’
e
Alignment Key
m
Igniter
s
exposed
—
Q
Burner Cap
.//==
\
//
GRILL COMPONENT
See the Grill Cooking Guide
NOTE: The grill grate must be preconditioned before
using it the first time. To precondition, first wash it in
soap and water and dry. Then use a paper towel to
apply a small amount of no-stick cooking spray to the
grate. Remove excess with a clean paper towel.
Use the grill for preparing meals with the appearance
and flavor of commercially char-broiled meats. The
OriHmust be very hot for this type of cooking and
a
smoke and spatter is to be expected.
Be sure to use your venting system when grilling
to help minimize smoke. You should have either a
component downdraft vent installed into the cooktop
system or a high-capacity vent hood.
The grill must be preheated to get the ~till
components hot enough to sear the meat and seal
in the juices. Preheat the grill on HI for 10 minutes.
See the Grill Cooking Guide.
The grill element is divided so the front and rear
sections are controlled separately. You can heat
both sections to the same temperature for cooking
large amounts of the same food, or you can VaIYthe
temperatures on front and rear for cooking two
different foods. Also, you can save energy when
cooking small amounts of food by turning only one
section on and leaving the other off entirely.
Grill Grate
Grill Element 4?
Drh Pan <
Electrical RecerXacles ~=,’ ~ ~/Z2
(continued nextpage)
Jar
I