Filter
Top Products
GAS BURNER CONTROLS
See the Gas Burner Component section.
The gas burnercontrols must tum counterclockwise
to the LITE position to ignite the burner.
Once the burner is ignited, turn the control knob
counterclockwise to adjustthe flame lower. A
sparking sound caused by the igniter is normal
until ignition occurs.
The burners will relight at any setting. However, for
the burners to light quickly and consistently when the
gas is turned on, the knobs should be turned to the
LITE position until ignition occurs.
When turning the control knob to off (0), turn
it clockwise.
GRILL/GRIDDLECONTROLS
See both the Grill Component and the Griddle
Accessory sections. Also see the Grill Cooking and
the Griddle Cooking Guides.
Most cooking on the ~till or griddle is done at the HI
setting. See the Grill Component section regarding
flame-ups andthe control settings for this emergency.
Each half of the grill component is controlled
separately.
The controlknob labeled GRIDDLE controlsthe
entiregriddle accessory.
The GRILIJGRIDDLE controls turn either direction
to adjustthe heat setting.
VENT SYSTEM CONTROL
To operate the vent system manually, turn the knob on
the control panel clockwise to the desired blower speed.
Use the control knob at the front of the vent ~tille to
~
●
adjust the blower speed. The control knob may be in a
●
custom location in the counter cabinet front. A HI
Bo” “
setting is recommended when flame-ups occur while
*
●
cooking on the ~till.
●
●
The downdraft blower adjacent to the till comes on
automatically when the ~till is turned on. It turns off
automatically when the ~till or ~tiddle is turned off (0).
If the blower speed is adjusted while ~tilling,
the blower will not turn off automatically and
must be turned off manually.
The built-in vent system helps remove cooking
vapors, odors and smoke from foods prepared on
the cooktop modules.
12