Filter
Top Products
21
Step 2
Locate
handle
position
• Determine the desired location of the custom handle
and mark centerlines of the screw holes.
• Drill 1/16" pilot hole through the panel until it starts
into the aluminum extrusion. This will mark the
matching location for drilling the clearance hole
when assembling the handle, panel and extrusion.
• Slide custom panel into the door trim.
• Temporarily secure the new handle extrusion to the
door using at least 2 screws.
• The custom handles must be located 3/4" to 1-1/2"
from the edge of the extrusion.
Step 3
Assemble
panel,
extrusion
and handle
• Remove the handle extrusion and custom panel.
• Drill 1/16" pilot hole through extrusion.
• Drill clearance holes through the panel and extrusion.
• Assemble the door panel, extrusion and custom
handle.
• Install screw(s) long enough to pass through the
extrusion, door panel and into the handle.
• Slide the assembly into the door frame until the new
extrusion fits firmly against the steel door.
• Reinstall original screws into the door extrusion.
3/4" Min.
1-1/2" Max.
Screw
Decorator
Door
Panel
Extrusion
3/4" Min.
1-1/2" Max.
Handle
Decorator
Door Panel
ZKHR1 Trim Kit (For 1/4" Panels)
Support for Custom Handles