Filter
Top Products
30
Step 2
Match
handle
extrusions
to handle
FOR CUSTOM
WOOD
PANELS
See Step 2A
for Stainless
Steel panels
• Cut a piece of corrugated to use as a pad to protect
the panel finish. Use 1/2" thick section of plywood to
protect flooring when drilling.
• Place custom panel on the pad, appearance side
down.
• On the back side of the panel - at the handle side,
measure and mark 1/4" below the top edge of the
panel with a pencil.
• Slip panel into new extrusion on the handle side of
the panel.
• Align the extrusion at the pencil mark, 1/4" below the
top of the panel.
• Tape the extrusion to the panel to prevent movement.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel over. On the appearance side, use 9/32" bit
to enlarge clearance hole.
IMPORTANT: Hole locations must be exact to accept
handle standoff and handle assembly.
If you are installing handle onto a Stainless Steel
Panel:
Use extreme caution if you are drilling through a
stainless steel panel. Stainless steel panels must be
handled gently. Do not kneel on the stainless steel
panel. It will leave a permanent dent. Do not remove
protective plastic covering until final installation.
• Place supplied filler panel (corrugated) on floor to use
as a pad.
• On the back side of the panel - at the handle side,
measure and mark 1/4" below the top edge of the
panel.
• Slip panel into the new extrusion, flush against inner
edge, on the handle side.
• Align extrusion to pencil mark as shown in Step 2.
Mark each screw hole location with pencil.
• Tape extrusion to panel to prevent movement.
• Place panel on plywood section, appearance side
down. Be sure plywood is clean without nicks and
burrs. Center punch at each screw hole location.
• Drill 1/8" pilot hole. Use 9/32" bit to enlarge clearance
hole.
• Measure and cut a 2" wide strip, top to bottom off the
corrugated panel. This will allow room for spacer rings
between the stainless panel and extrusion.
Step 2A
FOR
STAINLESS
STEEL
PANELS
Back
Side
Custom
Panel
Custom
Door
Panel
Extrusion
ZKHRSS1 Trim Kit (For 1/4" Panels)
Tubular Stainless Steel Handles