Filter
Top Products
Installation Instructions
10
7 INSTALL HOOD
Note: TWO PEOPLE ARE REQUIRED TO COMPLETE
THIS INSTALLATION!
• Lift the hood up to the support frame. Carefully align
the hood mounting studs into the support frame holes,
and at the same time, guide the hood duct connector
into the duct.
• Install 4 nuts and lock washers. Tighten with a 10mm
wrench.
• Check hood level in both directions.
• Check to be sure that the duct is positioned over the
hood connector.
• Seal the duct connection with duct tape.
Note: Do not drive screws through this duct connection.
Doing so will prevent proper damper operation.
Align
Mounting
Studs
Align Duct
Connector to
House Duct
Stop Screw
Install
4 lock
washer
and 4 Nuts
Bottom
Duct
Cover
8 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING: If house wiring is not 2-wire
with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be
sure to use UL approved anti-oxidant compound and
aluminum-to-copper connectors.
• Install strain relief onto the knockout of the
junction box cover.
• Insert house wiring through strain relief and
tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
or bare ground lead.
• Secure all connections with wire nuts on each
electrical connector.
• Push wires into junction box and replace cover. Be
sure wires are not pinched.