Filter
Top Products
Installation Instructions
9
6
INSTALL DECORATIVE DUCT COVERS
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installation
easier.
• Separate the two decorative duct covers.
• Select the inside (top) cover, which has vent hole
pattern at the top.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach to the hood support at the top with 2 supplied
decorative screws.
• Locate the stop screw in the envelope taped to the
front of the hood. Set aside.
• Slide the lower decorative duct over the installed upper
duct and push up, past the stop screw location.
• Install the supplied temporary stop screw in one of 3
holes in the support frame or the top duct cover to
prevent the bottom decorative duct cover from sliding
down.
CAUTION: The stop screw must be installed.
Failure to do so could result in personal injury or damage
to the duct cover.
Pretap
2 Screw
Holes
Top Duct
Cover
Install Screw on
Each Side
Bottom Duct Cover
Stop Screw
Top Duct
Cover
Bottom Duct
Cover
Top Duct
Cover
Install Stop
Screw in One
of 3 Holes