Filter
Top Products
Upper Charcoal
Filter Slots
Grasp Tab,
Lift and Pull Forward
Installation Instructions
11
9 SLIDE DUCT COVER DOWN,
INSTALL SIDE UTILITY BARS
• Hold the decorative duct cover and remove the
temporary stop screw from the support frame.
Return the screw to the service manual envelope
for future use.
• Slide the lower duct cover down onto the hood.
10 INSTALL FILTERS
• Remove protective film on charcoal filters.
• Tip charcoal filters into the upper (top) slots at the
rear of the opening. Grasp the filter tab, lift and
pull forward until it rests in the front slots.
• Install all 3 charcoal filters.
• Remove protective film from grease filters.
• Tip the grease filter into the lower slots at the rear
of the opening. Lift the filter and pull the knob
forward until the filter rests on the slots.
• Install all 3 grease filters.
• To remove the filters, grasp the knob, push the
filter towards the rear and tilt downwards. Grasp
tabs on charcoal filters, push towards the rear and
tilt downwards.
11 FINALIZE INSTALLATION
• Remove the protective film covering the control
panel on the front face of the hood, and any other
packaging materials.
• Refer to the Owner’s Manual for operating
instructions.
• Install the side utility bars with screws as shown.
Lower Grease
Filter Slots
Upper Charcoal
Filter Slots
Install Charcoal Filters
Install Grease Filters
Lower
Filter Slots
• There are two slots inside the back and front of the
hood. These slots will hold the charcoal filters and
stainless steel grease filters in place.