Filter
Top Products
12
EXTERNAL JUMPER
LOAD
LOAD
115 VOLT AC
60 CYCLE
(NEUTRAL)
(HOT)
BLACK BLUE
(500 Watt Max)
LIGHT
(7.5 Amps Max)
FAN MOTOR
RED
WHITE
FULL VOLTAGE
120 VAC
N
H
BLACK
SPEED CONTROL
WHITE
VARIABLE
VOLTAGE
FAN
AUX
DEVICE
SWITCHED FULL VOLTAGE
Dotted line indicates
for use with 10W
switch only.
RED
Model 5WSSC - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 115 - 127v, 5 Amp • UL Listed
• Require a 2x4 handy box
Model 5W240 - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 220 - 240v, 5 Amp • UL Listed
• Requires 2x4 handy box
Model 5W277 - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 277v, 5 Amp • UL Listed
• Requires 2x4 handy box
Model 8WSSC - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 220 - 240v, 8 Amp • UL Listed
• Requires 2x4 handy box
Model 10WSSC - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 115 - 127v, 10 Amp • UL Listed
• Requires 4x4 handy box
Model 15WSSC - For use w/ shaded pole and PSC motors.
Available shipped loose or mounted internal or external.
• Rated for 115 - 127v, 15 Amp • UL Listed
• Requires 4x4 handy box
Model GTD - Single switch controls both fan
and light. Available shipped loose.
• Silent Operation • Rated for 115v
• UL Listed • Requires 2x4 handy box
NEMA 1- Single pole rocker switch assembly.
• Rated for, 115v, 15 Amp, 1/2 Hp • UL Listed
Model MS-16- Single pole rocker switch assembly
with cover and pilot light.
• Rated for, 115v, 15 Amp, 1/2 Hp • UL Listed
NEMA 1 - Two pole rocker switch assembly.
• Rated for, 220/230/240/277v, 20 Amp, 2 Hp • UL Listed
• Requires a 2x4 handy box.
®
Time Delay Switch
Time delay switches save energy by automatically turning off equipment. They may be used with Models SP
and CSP fans and fan/light combinations, for extended operating time of fan. Time delay switches act in the
same manner as a standard switch, however, there is a delay of 1 to 60 minutes after the it has been turned off.
Switches
Switches may be used on Models SP and CSP fans to enable manual control of your fan or fan/light
combination. There are several options to fit your application.
Speed Controls
Speed controls may be used on Model SP and CSP fans for manual adjustment of the fan’s performance (for final
system balancing) or to control the fan’s output in confined spaces, such as conference or meeting rooms. The
fan can be adjusted to 60% of design airflow with a speed control. This reduction in airflow and fan speed is also
accompanied by a reduction in noise level. Solid state speed controls are available for a range of applications up
to 15 amps. Speed controls can be used to operate more than one fan if the combined total amperage of the
fans does not exceed the control rating.
AccessoriesAccessories