Filter
Top Products
American Metal Ware 67710E Coffee Urn Page 10
Operation
Now that the urn has been installed and started up, it is ready for operations. This section
describes the brew process from start to finish. Before brewing the first batch of coffee,
follow the procedure outlined here to brew an initial batch of water only into each liner. This
will rinse the components and set the gaskets and seals.
Load the Coffee
•
•
•
•
•
•
Start the Brew
•
•
•
•
Remove the pad lock which secures the liner cover over the liner into which you want to
brew.
Lift the cover to expose the brew basket. Note that the brew basket has a mesh bottom
so filter paper is not required.
If there are used grounds in the basket, dispose of them and rinse the basket
Fill the brew basket with the proper
amount of ground coffee to brew
ten gallons. Pour the coffee directly
into the basket - do not use filter
paper. See the following section for
instructions on the amount and grind
of coffee.
Check the liner. The liner should be
empty and clean before brewing a
batch. If the liner is not empty, it
will overflow when brewing.
Place the brew basket over the liner
and close the lid. You may padlock
the lid at this time to prevent
tampering.
Turn the brew lock key to ON for
the liner you are brewing to.
Check the WATER HOT light to be
sure the water is up to temperature.
If the light is off, wait a few
moments for the urn to finish
heating.
Be certain to close the cover over
the liner you wish to use.
Press the START switch for the
liner you are brewing to.
Figure 3, Brew Controls
WATER HOT
FILLING
COFFEE IN LINER
BREW LOCK
BREW LIGHT
START
STOP