Filter
Top Products
Electrical Requirements (cont.)
3. The body of the brewer must be grounded. A ground lug is provided for this purpose.
Initial Start-Up
1. Turn on the water supply to the brewer. Check for leaks at supply line to fill valve connection.
2. Make sure the power switch is turned to the “Off” position. The power switch is located on the upper back
panel of the brewer.
3. Plug in the unit’s power cord into a properly grounded receptacle.
4. Place the brew basket into the brew rails of the brewer.
5. With the dispenser’s cover removed, place the tea dispenser onto the tea brewer’s base.
6. The water tank needs to be primed. Press the Start switch to begin filling the water tank. After approximately
5 minutes the brew will terminate and the water fill valve will turn off. Drain off the dispensed water from the
dispenser and press the Start switch again to continue. You will have to perform this step until the water begins
to exit through the sprayhead. When this occurs, press the Stop switch. At this point the water tank is primed.
7. Turn off the power switch to energize the heating element.
8. When the water temperature has reached the preset temperature the Water Hot lamp will illuminate. This may
take between 15 and 35 minutes.
9. Check the brewer water temperature at the sprayhead. If the temperature needs to be adjusted, refer to
Adjustments section of this manual for instructions.
Use Control Functions
Power Switch: Controls the power to the heating element for the water tank.
Start Switch: Press to start a brew cycle.
Stop Switch: Pressing this switch during a brew cycle stops the cycle prematurely. Note: After the switch is
pressed, adequate time must be given to drain the brew basket before removing from the unit.
Hot Water Light: Light illuminates when the water reaches the proper brewing temperature.
American Metal Ware
®
Tea Brewers Page 4
!
WARNING: ELECTRIC SHOCK HAZARD
NEVER USE THE GROUND CONDUCTOR AS A NEUTRAL. THIS COULD CAUSE
ELECTROCUTION.
!
CAUTION: HOT LIQUID HAZARD
TEA BASKET CONTAINS VERY HOT LIQUID UNTIL THE DRIP-THROUGH IS COMPLETED.
EARLY REMOVAL OF THE BASKET COULD RESULT IN BURNS.