Filter
Top Products
Cleaning Procedures (cont.)
Daily Cleaning
Cabinet: The outside of the machine can be cleaned with a damp cloth, a household dusting spray or a stainless
steel cleaner. Do not use an abrasive such as Scotchbrite or Brillo pads. These may mar the finish.
Wipe the underside of the cabinet hood with a clean cloth. Be especially careful when using soap or detergent
around the sprayhead. Any soap left on the deflector may impart an unpleasant taste to the first brews.
Weekly Cleaning
Brew Basket: Use commercial grade urn cleaner (as directed by manufacturer) and rinse thoroughly.
Service
The remainder of this manual contains information to aid the service person making repairs to this equipment. This
section has information on performing common service tasks. A section on troubleshooting follows and can be used
to help determine the cause of problems with the equipment.
An illustrated parts breakdown follows and will aid in correctly identifying replacement parts. For factory assistance,
call 1-800-695-4500 between 8:00 a.m. and 5:00 p.m. Eastern time.
Finally, wiring diagrams are provided for the various models covered by this manual.
To Drain Water Tank
1. Turn off the power to the brewer and allow to cool before draining.
2. Remove the lower front panel.
3. Pinch or clamp the tube from the needle valve assembly to the tank and
disconnect the tube from the needle valve assembly. Place the tube over
a drain, release the clamp, and allow the tank to drain.
4. Reconnect tube to bottom of tank when finished draining.
American Metal Ware
®
Tea Brewers Page 7
!
WARNING: BURN HAZARD
HOT LIQUIDS AND SURFACES ARE PRESENT IN THIS EQUIPMENT. TO AVOID BURNS
USE CAUTION WHEN CLEANING. RINSE HOT PARTS WITH COLD WATER BEFORE
CLEANING. USE GLOVES OR HEAVY CLOTH WHEN REMOVING HOT PARTS FROM
BREWER.
Figure D